My CapriceSS

CaminoKid Garage

What other mods are planned or have been DONE: 

       & Check out my AfterMods Page for pictures of the completed mods

1. BMR upper and lower extended length control arms - DONE - Look at the Difference

2. GM Export pipes with O2 Sensors bung welded in to keep O2 sensors - DONE

3. 3.5 inch DynoMax UltraFlow cat back exhaust system ---> Click here to download sound bite - DONE

4. Modified rear brake proportioning valve to allow more rear braking - DONE

5. 9C1 front dust shields & air deflectors - DONE

6. A-Pillar 3 gauge pod for tach, temp & o/p - DONE

7. Synthetic fluid for the engine, transmission & rear differential - DONE

8. How about an SLP Ram Air Hood - DONE

9. F-Body mass air flow sensor - DONE

10. Custom PCM programming & LT4 Knock Module - DONE

11. Throttle body coolant by-pass & 160 Degree Thermostat - DONE

12. Lower body bushings MISSING from the plant??? - Reference TSB 43-20-01 - DONE  Check this Out!

13. Rear axle powder coated & 3.73 axle ratio installed w/aluminum differential girdle/cover - DONE

14. Aluminum 3.5 inch drive shaft - DONE

15. Rear 315/35ZR17 on a 10.5 widened factory rim and Front 275/40ZR17 - DONE

16. 1996 Impala SS floor shifter & center console

17. 396 big cubic inch LT1, can we say storker???  ---> This LT1 is the perfect candidate! - Check it out--> 396 LT1 - Bare Block

18. Durastop brake pads & rotors?  SSBC Dual piston calipers? Hhmmmm????

19. S-10 torque converter P/N 24202310

20. Rear window glide conversion - P/N 9666748, you will need 3 per side

21.